Digilent Genesys 2 Board
The Digilent Genesys 2 board is an advanced, high-performance, ready-to-use digital circuit development platform based on the latest Kintex-7™ Field Programmable Gate Array (FPGA) from Xilinx. With its high-capacity, high-speed FPGA (Xilinx part number XC7K325T-2FFG900C), fast external memories, high-speed digital video ports, and wide expansions options make the Genesys 2 well suited for data and video processing applications. Several built-in peripherals, including Ethernet, audio and USB 2.0, allow a wide range of other applications. The fully-bonded1) high-speed FMC HPC connector opens the door to great expansion possibilities.
Features- 50,950 logic slices (from Genesys up 7x), each with four 6-input LUTs and 8 flip-flops
- Close to 16 Mbits of fast block RAM (up 7x)
- Ten clock management tiles, each with phase-locked loop (PLL)
- 840 DSP slices (up 17x)
- Internal clock speeds exceeding 450MHz
- On-chip analog-to-digital converter (XADC)
- Up to 10.3125Gbps gigabit transceivers
- 1800Mbps DDR3 data rate with 32-bit data width
- Commercial -2 speed grade
- Fully bonded 400-pin FMC HPC connector
- USB-UART Bridge
- 8 user switches, 6 buttons
- OLED
- VGA connector
- Pmod for XADC signals
- Two four-lane DisplayPort connectors
- HDMI Sink and HDMI Source
- 10/100/1000 Ethernet PHY
- 1GiB 1800Mt/s on-board DDR3
- USB 2.0 Host/Device/OTG PHY
- Digilent Adept USB port for programming and data
- Ten GTX lanes available in the FMC connector
- Micro SD card connector
- Audio codec w/ four 3.5mm jacks
- Serial Flash
- Five Pmod ports
- USB HID Host for mice, keyboards and USB MSD Host for storage
